MPP Power Pipe

Product Introduction

MPP power pipe uses modified polypropylene as the main raw material. It is suitable for laying pipelines, cables, and other construction projects in special sections such as roads, railways, buildings, and riverbeds without the need for extensive dredging, excavation, or road surface destruction. Compared to the traditional "trenching and burying method," trenchless power pipe engineering better meets current environmental protection requirements, eliminating nuisance factors such as dust and traffic congestion caused by conventional construction. This technology can also be used to lay pipelines in areas where excavation is not feasible, such as heritage conservation areas, downtown districts, crop and farmland protection zones, highways, and rivers.

Product Features
1. MPP power pipe has excellent electrical insulation properties.
2. MPP power pipe features high heat deformation temperature and low-temperature impact resistance.
3. MPP power pipe offers higher tensile and compressive strength than HDPE.
4. MPP power pipe is lightweight, smooth, has low friction resistance, and can be thermally welded for对接.
5. The long-term service temperature of MPP power pipe ranges from -5°C to 70°C.

Product Application Areas
1. Widely used in pipeline projects for municipal utilities, telecommunications, power, gas, water supply, and heating.
2. Trenchless horizontal directional drilling power duct projects in urban and rural areas, as well as open-trench power duct projects.
3. Trenchless horizontal directional drilling sewer pipeline projects in urban and rural areas. Industrial wastewater discharge projects.
4. Agricultural irrigation and drainage.

Power Pipe Construction Guidelines
1. During transportation and construction, avoid throwing, impact, scratching, or exposure to direct sunlight.
2. Ensure proper alignment of pipe axes and perpendicular, flat end faces during thermal fusion对接.
3. Adjust processing temperature, time, and pressure according to climate conditions.
4. The minimum bending radius of the pipe should be ≥75 times the outer diameter.